![]() ![]() Not all the Minn Kota trolling motor models are i-pilot compatible. In that case, it will be better to replace than clean. Remember, if the circuit board remains dusted for a long time, cleaning it won’t work. Spray down the WD-40 back and forth to wipe the crud. Solutionĭisconnect the pedal and take off the circuit board and contact tab. ![]() At that point, the trolling motor won’t turn right or get too slow to turn, unlike the left-side-turning condition. Debris or dirt gets under the contact tab and creates friction holes in the circuit board which cause the foot pedal to go out. Well, this issue happens when the circuit board gets dirty. Problem 3: Trolling Motor does not Turn RightĪnother common problem with Minn Lota trolling motor is the foot pedal sometimes gets stuck and doesn’t turn right. It is the easiest way to take care of the cables of your trolling motor. The zip ties will protect them and allow them not to be rotten. Use zip ties or PET sleeving to cover the cables in a good way. If the cables get rotten, the foot pedal cannot work. And, it delivers a direct link between the foot pedal and the motor. The cable-steering trolling motors are operated through the cable drive. Or else, any of the parts can be damaged. However, keep the sliding parts clean but it’s crucial to clean them with the right substance. Again, vaseline and q-tip can be another solution to cleaning these critical parts. You can try the WD-40 through a towel, it really works fine. Take the sliding parts off and clean them with a substance that won’t attract dust or damage the parts. ![]() If the sliding parts are dirty, the slider won’t slide smoothly in the required direction which will make the Minn Kota foot pedal stuck. In that case, the sliding parts or circuit boards are in the first phase. ![]() It’s normal not to clean the different parts of the trolling motor for a long time. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |